NCT AL NASHI ALEX SDN BHD
 
English | 中文简体
NCT AL NASHI ALEX SDN BHD (NCT) was developed in Europe over 60 years ago and has since then been on the international market for more than 20 years. NCT has been used in the building industry for well over one hundred thousand apartments and houses in over 40 different countries. Machines, foaming agent, training and technology transfer
Foam Concrete
Introduction

About NCT
Application
Benefits
FAQ
SIRIM QAS Test Reports and Certifications
Charts
Foam Generator, NCT Mixer and PUMPS
Casting of Wall
Casting a House
NCT Formwork System
Blocks & Panels
Road Barriers & Sound Barriers
Pavers & Cornices
Undulating problem solving with NCT Bridge Approach system
Highrise External Wall Panels
Screeds, Floor Stampings & Road Base
Video
Conclusion
Contact

> Blocks & Panels

Lot 78, Jalan Beserah, ( Opposite TAN CHONG - NISSAN Showroom ), 25300 Kuantan, Pahang, Malaysia.
Tel : +6-09-5162911 or +6-09-5162912 Fax : +6-09-5162913
Email : alex@al-nct.com or lightweightconcrete@yahoo.com

As NCT innovative lightweight concrete densities can be control, we are able to make blocks and panle of verious shapes and sizes as well as density ranging form 600 kg/m3 to 1600 kg/m3. For exampl;e a 100mm thick (4") blocks of size 200mm x 450m ( 8" x 18") it can be made to 6 kg per ( if using 600 kg/m3 dry density cement only mix), 7 kg, 8kg, 9 kg ( if at 900 density) up to 16 kg per block if at 1600 density ( cement and fine sand mix for those above 1000 density)
       
       
       
Manufacturing of block panels to any require size with density ranging from 500 kg / m3 to 1800 kg /m3. Metal, wood or plastic mould could be used. Oiling of mould is compulsory. After years of experimental and testing, we are in a position to advise or to supply you with the perfect mould. We advised customer to manufacture 300mm x 600mm panels, thickness varies from 75mm to 150mm. It's the perfect wall because of its excellent sound and heat insulation properties.

Panel with Density of 600 to 800 kg / m3 can be to size as large as 300mm x 1200mm x 100mm thick can still be lifted by a single worker. It can float on water.

Purpose LEGO type block panel in which a steel bar as well as wiring conduit or water pipe can be inserted and fill again with lightweight concrete to make a very strong load bearing wall or retaining wall. It can be cast to any require size.



Laying of load-bearing block with hollow section infill again with Lightweight Concrete and coated with a single a layer of skim-coating finishing. No columns and beams are required.



NCT - All kinds of blocks and panels can be cast with Lightweight Concrete Methods. Densities of blocks and panels can be adjusted to between 900 kg/m3 to 1800 kg/m3.



Compressive strength of NCT is between 1 MPa to 30 MPa. It has good heat insulation properties and is a very good acoustic material. Densities lower then 800 actually floats in water. Panels can be cast with stone effect finish appearance. Lightweight panels as thin as 25 mm thickness and mix with pigments can make decorative colour instead of normal cement colour appearance.

Copyright © 2010 NCT (0008236-V). All rights reserved. Powered by Website Solution | AdrianCJY.com.